Use this Barb Tubing Tee insert fitting to connect three sections of tubing together.
Quality barbed fittings provide high retention in low-pressure poly tubing for long-term reliability of connections. The acetal fittings can be confidently installed without clamps when matched with our quality low-pressure poly tubing with corresponding dimensions. See note below on gray PVC fittings.
Features:
Sharp-edged barbs create leak-proof seal
Increased strength and superior quality
Heat, chemical and wear-resistant
UV stabilized materials for long life
Special Note:
1/4″ barbed fittings have the unique ability to be “snapped” into larger tubing after punching a hole into the side of the larger tubing with any of our 1/4″ punch tools. This creates a water-tight seal and allows you to “tee-off” of larger diameter tubing using only 1/4″ fittings and a hole punch.
Fitting Size
Acceptable Inside Tubing Diameter
Fitting Use
Max Operating Pressure
1/8″
.125″
To connect sections of 1/8″ tubing or to connect 1/8″ tubing to mainline tubing
Up to 30 PSI
1/4″
.170″
To connect sections of 1/4″ tubing or to connect 1/4″ tubing to mainline tubing
Up to 30 PSI
1/2″
.570″ to .620″
To connect sections of 1/2″ poly tubing together
Up to 30 PSI
3/4″
.805″ to .820″
To connect sections of 3/4″ poly tubing together
Up to 40 PSI
1″
1.06″
To connect sections of 1″ poly tubing together
up to 40 PSI